Name:
Damascus pattern steel
Features:
Practical laminated steel, about 60 layers overall, VG10 in the middle clamp
Heat treatment:
Clamped steel HRC 58 degrees +-1, taking into account sharpness and toughness (vacuum deep cooling heat treatment)
Pay special attention to the problem:
1: There is a flat grinding and simple acid pickling, but after the molding / open V, you still need to pickle again (new friends, please be sure to look at Baidu tutorial, this is very important, people who know how to see can be genuine);
2: The two-sided pattern of the steel may not be pure to the same thickness because of the relationship between the segments, and the texture of the two sides may also be different;
3: It is not pure to all straight, the steel will have slight stress deformation during heat treatment. This is the characteristic of all steel embryos. All of these require friends to go back to DIY to their own satisfaction, hands-on ability and perseverance. The heart is strong, you have to have some necessary tools such as: grinder;
Note
Due to forging and cutting, each size has an error of 1-3MM
If you want to buy other size ,you can contact us
Polished, there will be no pattern
The blade body must be acid-polished and then soft-polished to obtain a noticeable effect (absolutely not printed). However, the use of sharpening stone or sandpaper to deliberately polish the pattern part is a pattern that can be worn off, and it is necessary to re-acidify after grinding to reproduce the pattern. Normal use and sharpening (grinding edge) will not remove the pattern.