10S 100a lipo lithium Polymer BMS/PCM/PCB battery protection board for 18650 Li-ion Battery Cell with balance with temperature switch with APP
Note: this BMS with balance function. your battery need match, battery should have good consistency, if not sure, please use new brand battery.
USB_to_serail module or Bluetooth should use together with the board.
USB_to_serail module connect to PC by USB, so you can monitor the board, and set the parameter.
Bluetooth module can connect to smart phone, right now only support android 4.3 above.
APP support english
about software, please contact seller.
after order, seller will give you APP link.
Features:
1) high-accuracy voltage detection circuit;
2) terminal of the charger using high voltage device;
3) Built-in three-stage over-current detection circuit (over-current 1, over-current 2, or load short circuit);
4) MOS transistor can control the battery charge and discharge;
5) low standby current consumption.
6) with UART interface, Bluetooth interface, support PC or smart phone.
7) over charge and over discharge can set by software( APP).
100A version: continuous work current 100A, over current protect is 200A.
80A version: continuous work current 80A, over current protect is 160A.
100A version Parameter:
charge voltage: 4.2V * 10 = 42V
continuous work current: 100A
over charge: 3.6~4.3V
over discharge: 2.0~3.3V
balance voltage: 3.3~4.2V
balance current: 50mA
parameter can set by software(APP).
parameter can set by APP, follow table is DEMO
version S: charge and discharge use difference port
charge: B+ and P-
discharge: B+ and P-
Wiring sequence: First solder line B- to battery negative, connect balance cable to battery(B1 B2 ... B10), insert the cable(socket), After check, then connect P- line, then look at the amount of the total voltage of the battery, if the voltage between P- and B+ equal the total voltage, it’s should be work properly.
step 1: connect battery, check carefully
step 2: plug the balance cable, first low bit, last high bit.
Applications:
10S Li-ion18650,LiCoO2,LiMn2O4,Li(NiCoMn)O2 rechargeable batteries
10S Lipo rechargeable batteries
Notice:
1. Please pay attention to the use condition of input and output voltage and load current , make the protective plate within the power consumption of no more than specification allows power consumption;
2. Connect the battery will happen cannot discharge status, in this case, connect the charge can be restored to normal working state;
3.If a set of batteries with over-discharge and over-charge cells, the bms cannot be charge and discharge.
![](https://ae01.alicdn.com/kf/HTB1xcaPLXXXXXagXXXXq6xXFXXXJ/224459592/HTB1xcaPLXXXXXagXXXXq6xXFXXXJ.jpg?size=70130&height=375&width=500&hash=2a614d875d4b1cf945cab159d4049fad)
about software, please contact seller.
after order, seller will give you APP link.