8S 60A LiFePO4 BMS/PCM/PCB battery protection board for 8 Packs 18650 Battery Cell w/ Balance
Application:
AGV moving car, power tools, electric motorcycles.
Features:
1) high-accuracy voltage detection circuit;
2) terminal of the charger using high voltage device;
3) Built-in three-stage over-current detection circuit (over-current 1, over-current 2, or load short circuit);
4) MOS transistor can control the battery charge and discharge;
5) low standby current consumption.
Parameter:
over charge: 3.85V
over discharge: 2.3V
charge voltage: 3.6V * 8 = 28.8V
continuous work current: 60A
over current: 80A
balance voltage: 3.55V
balance current: 70mA
size: 103mm * 75mm * 8.5mm
wiring diagram:
B8+(P+) charge/discharge positive
P- charge/discharge negative
Notice:
1) Please note that the input and output voltage, and load current conditions for power protection board does not exceed the electrical parameters of the allowable power consumption;
2) special attention to the load current can not work long hours between maximum continuous operating current and over-current protection current;
3) When connecting the battery ,it may not discharge. In this case, connect the charger can be restored to normal working condition;
4) Although the BMS built-in electrostatic protection circuit, but please do not hand touch when BMS in the working condition, so as to avoid damage from static electricity protection board.
5) If the picture is not the same as the parameters,please check according to the parameters table.
6) Please note that it is without balance function.
SMT Workshop: