Transmitter
It is a RF Transmitter Board without case and the Button, Just Input DC3V-DC12V Power for it, It will transmitting Signal, It is a Micro Transmitter Module for Learning Code Receiver. The Transmitter Module can be controlled by Smoke Detector or others Sensor or Microcontroller.
Working Voltage: DC3V-DC12V
(The Best Voltage is DC9V-DC12V, DC3V Distance will be Shorter)
Input DC3V-DC12V for the Receiver, It Transmitting Signal
Modulation Mode: ASK
Quiescent Current: 0uA
Working Current: 8-10 ma
Transmitting Power: 35-50mW
Encoding Type: Learning Code (Ev1527)
Transmitting Distance: 100-300m
Receiving Sensitivity: 108dBm
Size: 21*11*5mm
Receiver
1.Working Voltage: AC220V +- 10%
2.Max Load:10A Relay, Resistive load≤8A, Inductive load≤3A
3.Channel: 1CH
4.Working Frequency : 315MHZ/433MZH Optional
Receiver sensitivity: : -105Db
Working temperature : -10&39;C - +60&39;C
Output way : Momentary. Toggle .Latched Adjusted by Jumper
Code type: Learning code Add Controller by the Learning Button on the receiver
Output State:
It is adjusted by the Jumper on the Receiver Board,
(before you change it .you need turn OFF the power. Until you have changed it, then turn ON the power again, or the State will not be changed)
A: Momentary-----------Put the Jumper on “T&G”.
B: Toggle------------put the Jumper on “M&G”
C: Latched------------- Take way the Jumper or put the Jumper on any 1 Pin.
Momentary------------Press the Transmitter button A, the receiver relay A is ON, release button A; the receiver relay A is OFF,
Toggle---------------Press transmitter button A for 1 time , the receiver relay A is ON, press button A again, the receiver relay A is OFF,
Latched------------Press transmitter button A, the receiver relay A is ON, Press transmitter button B, the relay A OFF.
Learning Method
Input AC220V for the Receiver .Press the Learning Button until the Led indicator ON. Then press transmitter, the Led indicator flash fast, it mean learning successfully.
Clearing Code
Keeping press the Learning Button on the receiver until the LED indicator ON and flash fast, it mean the code have been cleared successfully.