Technical Data:
Input Power: AC 85V-250V
Standby Current:<8.5MA
RF Frequency: 433Mhz
RF working mode: superheterodyne
Receive sensitivity: > 97 dbm
Transmitting distance: More than 15 meters
Decoding mode: MCU software decoding
Learnable Transmitters: 1 - 20 transmitters
Support remote type: Learning code (1527)
Switching Modes: Momentary and Toggle
Wiring type: fixed terminal
Switch Output : normally open & normally closed.
Dimension of PCB (L,W,H) 68*47*26mm
Switch Output:
NO: normal open
COM: common
NC: normal close
Instruction
HOW TO USE:
On this products details page, there is a demonstration video available
You can also see the video at this URL: https://youtu.be/k06q76qthBw
Working Modes explanation:
Momentary Mode:
Press the remote button, the relay (on the receiver) activates;
release the remote button, the relay deactivates.
Toggle Mode:
Press and release the remote button , the relay (on the receiver) activates.
Press and release the remote button again and the relay deactivates.
** Note **
After clearing the stored transmitters, all transmitters will need to be relearned by the receiver.
Push the learning button on the receiver 8 times, and the codes will be cleared .
Learning the transmitter : (momentary Mode)
STEP 1
Press and release the learning key on the receiver once.
Wait for a moment , the LED will turn off , indicating you entered the learning state.
STEP 2
Press and release the first button on your transmitter, the LED on the receiver board will flash on then off indicating the button was learned.
STEP 3
Press and release the second button on your transmitter, watching the LED go on and off again.
Wait 3 seconds, the LED will turn on again, indicating system is ready for use.
Learning the transmitter : ( Toggle Mode )
STEP 1
Press and release the learning key on the receiver twice.
Wait for a moment , the LED will turn off , indicating you entered the learning state.
STEP 2
Press and release the first button on your transmitter, the LED on the receiver board will flash on then turn off.
Indicating the button was learned.
STEP 3
Next press and release the second button, watching the LED go on and off again.
Wait 3 seconds, the LED indicator will turn on again , indicating system is ready for use
** Notice **
Two button transmitters can only be used as toggle or momentary.
One mode per 2 button transmitter.
(Please note: You let the control panel to learn the remote control, you must press the "A" and "B" button; Rather than just pressing one of them )
However you can program another transmitter in the other mode.
Wiring diagram