7S 30A lipo lithium Polymer BMS/PCM/PCB battery protection circuit board for 10 Packs 18650 Li-ion Battery Cell with temperature switch with balance function
This BMS can use in electric bike e-bike ebicycle application
Note: your battery need match, battery should have good consistency, if not sure, please use new brand battery.
Features:
1) high-accuracy voltage detection circuit;
2) terminal of the charger using high voltage device;
3) Built-in three-stage over-current detection circuit (over-current 1, over-current 2, or load short circuit);
4) MOS transistor can control the battery charge and discharge;
5) low standby current consumption.
30A version Parameter:
over charge: 4.25V
over discharge: 2.8V
charge voltage: 4.2V * 7 = 29.4V
continuous work current: 30A
over current: 60A
balance voltage: 4.2V
balance current: 50mA
size: 69mm * 57mm * 15mm
wiring diagram
B+ charge/discharge positive
C- charge/discharge negative
charge: B+ and C-
discharge( load) B+ and C-
Order of connection: unplug the cable, start from B- then B1 B2. B7, check the voltage, if ok, then plug the socket(balance cable),
step 1: connect battery, check more carefully.
step 2: plug the balance cable, first low bit(BC0), last high bit(BC7).
Applications:
7S Li-ion18650,LiCoO2,LiMn2O4,Li(NiCoMn)O2 rechargeable batteries
7S Lipo rechargeable batteries
Notice:
1. Please pay attention to the use condition of input and output voltage and load current , make the protective plate within the power consumption of no more than specification allows power consumption;
2. Connect the battery will happen cannot discharge status, in this case, connect the charge can be restored to normal working state;
3.If a set of batteries with over-discharge and over-charge cells, the bms cannot be charge and discharge.